![]() ![]() ![]() If you have a screw drive or chain glide unit you need to set the limit closer to the motor, so the opener shuts off earlier (at the point the door closes). In the down direction, if the limit is set beyond the point at which the door closes fully, the door will hit the floor and act as if it is hitting something and the safety feature tells it to reverse. These limits set the distance the door will open or close before stopping. You have an open limit and a close limit on your garage door opener. The garage door closes down to the floor, hesitates and reverses back up to the open position. You can find new sensors on our Web site in the category section or by going directly to Infra-Red Sensors.Ģ. ![]() If nothing works, it may be that you have to replace the sensors. This acts as a reset and may reset the sensors. Also, try unplugging the garage door opener and re-plugging the unit back into the outlet. To try and correct the problem, make sure the eyes on the sensors are clean, the wire connections are securely fastened at the sensors and motor head, and the eyes are directed at each other. This method is the only way to override the safety and close the door. When this happens your garage door will only close by holding down on the wall button, or wall console, until the door fully closes. You will find that the door will only move an inch or so in the close direction and reverse. The transmitters (remotes) will not work to close the garage door. The problem is either due to a blocked path between the sensors, dirty eyes, loose wires at the sensors or at the motor head, or just bad sensors. (If Applicable)When the infra-red sensors are malfunctioning, usually one of the sensor lights will be blinking. Snap the two halves of the remote control back together and replace the screw & visor clip.Replace with a new battery making sure that the battery is oriented correctly.Use the provided slot(s) at the seam corners to pry remote control open. Use a small flathead screwdriver to pry rear cover loose.Remove small phillips head screw on the back of remote control.Pull firmly on visor clip to release (If Applicable).Be careful not to lose this small selector switch during disassembly and reassembly. NOTE: Some types of these remote controls will have a DUAL FREQUENCY SWITCH on the side. Snap the two halves of the remote control back together and snap remote back into the dock.Push coin cell battery out of the holder.Use the provided slots at the seam corners to pry remote control open. Push on corners of the docking station to release remote control, and remove keychain ring.Push coin cell battery out of the holder (see below).Use a small flat head screwdriver, working along both sides, pry rear cover loose between the cover seam.If you have a newer style remote, the instructions can be found on that specific remotes product page. Coin Cell Battery (34472B) Replacement Instructions for Genie Garage Door Opener RemotesĬhoose the type of Genie Intellicode remote that you have, then follow the instructions below. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |